7-16
Driver assistance system
OJWEV071003LOJWEV071003L
• When the vehicle is stopped due
to emergency braking, the ‘Drive
carefully’ warning message will
appear on the cluster.
For your safety, the driver should
depress the brake pedal immediately
and check the surroundings.
•
Brake control will end after the vehicle
is stopped by emergency braking for
approximately 2 seconds.
If the collision angle with the crossing
Junction Crossing function warning and
Information
The audible warning can be turned off
while collision warning or emergency
braking is operating by pressing the
hazard warning flasher button.
Lane-Change Oncoming function (if
equipped)
Warning and control
Lane-Change Oncoming function will
warn and control the vehicle depending
on collision risk level: ‘Collision Warning’
and ‘Emergency Steering’
Left-hand driveLeft-hand drive Right-hand driveRight-hand drive
OJWEV071009LOJWEV071009L OJWEV071010LOJWEV071010L
Collision Warning
• To warn the driver of a collision, the
warning light will blink and the
‘Collision Warning’ warning message
will appear on the cluster
, an audible
warning will sound and the steering
wheel will vibrate.
•
The function will operate when
your vehicle speed is between
approximately 40-145 km/h (25-90
mph) and the detected oncoming
vehicle or powered two-wheeler
speed is approximately above 10 km/h
(6 mph) and the relative speed with
your vehicle is approximately below
200 km/h (124 mph).
To Next Page
Loading...
