Part No. 40462 DPL-25S • DPL-30S • DPL-35S Super Series 4 - 7
September 2016 Section 4 - Scheduled Maintenance Procedures
Table B Procedures
B-1
Inspect the Electrical Wiring
Maintaining electrical wiring in good condition is
essential to safe operation and good machine
performance. Failure to find and replace burnt,
chafed, corroded or pinched wires could result in
unsafe operating conditions and may cause
component damage.
Electrocution/burn hazard. Contact
with hot or live circuits may cause
death or serious injury. Remove
all rings, watches and other
jewelry.
1 Inspect the following areas for burnt, chafed,
corroded and loose wires:
• All base wiring
• Inside of the ground control box
• Inside of the base junction boxes
• Hydraulic power unit
• All external machine electrical cables
• Inside of the platform control box
• DC models: battery and charger
• AC power supply cord
B-2
Inspect All Welds
Weld inspections are essential to safe machine
operation and good machine performance. Failure
to locate and repair damage may result in an
unsafe operating condition.
1 Visually inspect the welds in the following
locations:
• Platform and platform components
• Base
• Mast brace mounting brackets
• Ladder mounting bracket
To Next Page
Loading...
Need help?
General
