Total Station Manual
92
angle.
Distance measurement: [F1]
(ALL)or[F1]+[F2](DIST+
REC).
ƻ
9
When finish a known
point measurement, press [F2]
(NEXT PT) to start next
known point measurement.
Repeat steps
ƻ
7and
ƻ
8.
[F2]
ƻ
10
If the measured known
points are enough, [Result]
will display on the screen,
then press [F3] (Result) to
enter the [Station Coordinate]
to view station result.
Press [F1] (Back) back to a
new known point
measurement.
Press [F2] (errors) to display
standard deviation.
Press [F4] (OK) to set the
station coordinate and
instrument height.
Press [F3] (Result) to enter the [Station
Coordinate] to view result.
Display standard deviation:
To Next Page
Loading...
