GeoMax ZOOM 10 - Page 97

Total Station Manual
96
ƻ
5 Start to measure the
second target point. Aim at
the second target point and
press [F1](ALL) or
[F2](DIST) + [F3](REC) to
finishing measurement.
Ć
1
PAGE1
Press
[F1]
or
[F2] +
[F3]
ƻ
6
Show the result of
polygonal tie distance.
[NewPt1]: Start a new
polygonal tie distance.
[NewPt2]: This polygonal tie
distance’s second point will
be the new polygonal tie
distance’s first point and then
go to
ƻ
5 to measure the new
second target point.
[Radia]Radial: Go to Radial
tie distance.
Ć
1
: The target points can be measured, selected from the memory, or input usingthe
keypad.