64
[Video Slice Mode] Note this function is only supported by firmware V2.12
or earlier and is not supported by Target Series and GV-IPCAM H.265.
Corrects the display mode of the camera when it is displayed on third-
party NVR/DVR software and the live view is incomplete or broken. Select
Single Slice or Multi Slice to display the live view. The default is Auto.
[H.264 Video Entropy Coding Setting] Note this function is not supported
by GV-IPCAM H.265 and GV-BX12201. By default, the entropy coding is
set to CAVLC. To change it to CABAC, click and select from the drop-
down list.
[Record Settings] Note for GV-BX12201 firmware V1.02 or later and GV-
IPCAM H.265, see Recording Settings in 4.5 Monitoring Settings to adjust
the setting.
The alarm settings allow you to capture images before and/or after the
motion or I/O events happen.
Pre-alarm recording time: Activates video recording before an event
occurs. Set the recording time to 1 or 2 seconds. The recording is
saved in the buffer of the camera.
Post-alarm recording time: Activates video recording onto the
inserted memory card after an event occurs. Set the recording time
from 1 to 30 seconds.
Split-interval (Max. Video Clip): Sets the maximum time length of
each recorded file from 1 to 5 minutes.
To Next Page
Loading...
Need help?
General
