3-4
Managing Power
NOTE: The battery level may automatically lessen due to the self-discharge
process (0.21% per day), even when the battery pack is fully charged (100%).
This happens no matter if the battery pack is installed in the tablet PC.
Initializing the Battery Pack
You need to initialize a new battery pack before using it for the first time or
when the actual operating time of a battery pack is much less than
expected.
Initializing is the process of fully charging, discharging, and then charging.
It can take several hours.
1. Make sure that the tablet PC power is turned off. Connect the AC
adapter to fully charge the battery pack.
2. After the battery pack is fully charged, turn on the tablet PC. Press the
Ent key when the prompt appears on the screen during system startup.
The prompt shows up on the screen for only a few seconds. You must
press the Ent key quickly.
3. A small window appears, select Launch System Setup to invoke the
program.
4. Disconnect the AC adapter and leave the tablet PC on until the
battery is fully discharged. The tablet PC will shut down automatically.
5. Connect the AC adapter to fully charge the battery pack.
Checking the Battery Level
NOTE: Any battery level indication is an estimated result. The actual operating
time can be different from the estimated time, depending on how you are using
the tablet PC.
By Operating System
You can check the approximate battery level using the battery meter
function of the operating system. To read the battery level in Windows,
To Next Page
Loading...
Need help?
General
