getAir SmartFan - Further Functions

29
EN SmartFan
6.3.3 Further functions
Full blast mode: changing airow direction
When in full-blast mode, press the „Up arrow“ and „Eco-Mode“ concurrently to reverse the
initialairowdirection.TheLEDsblinkasconrmation.Tochangetheinitialairowdirection,
press the „Down arrow“ and „Full-blast mode“ concurrently. Here again, the LEDs blink as
conrmation.
Filter change display
Whenalterchangeisrequired,themiddletwoLEDsstartblinking.Oncethelterhas
beenchanged,thisisconrmedbypressingthetworoundbuttonsinthemiddleconcur-
rently. In doing so, the internal meter is also reset.
THE OPTIMAL TIME FOR CHANGING A FILTER IS DEPENDENT ON LOCAL
CONDITIONS AND CAN THUS VARY.