Getidy JN-23 - “Abnormally Exit” Function

4.6“Abnormally Exit”function
If you wish to stop the running program, you can click the stop(Fig.4.6-1) and select OK(Fig.4.6-2) .
The LCD screen will show E00 alarm code and alarm cause.After you click on start (Fig.4.6-3),into automatically.(Fig.4.6-4)
After about 3 minutes, the program will be finished. When the screen show the sterilization program initial
interface, you can open the door and bring out the medical instrument inside chamber.
Fig.4.6-1 Fig.4.6-2 Fig.4.6-3 Fig.4.6-4
Page 26 of 58