Getidy JN-23 - Sterilization Program Details

Program sterilization sterilization drying vacuum
Name temperature time time times
134 04min 09min 1 times
134 04min 15min 3 times
134 18min 15min 3 times
121 30min 15min 3 times
121 20min 09min 1 times
℃
℃
℃
℃
℃
134 or 121 03~60min 01~60min 1or 3 times℃ ℃
1.Solid
2.Hollow
3.Prion
4.Cotton
5.Plastic
6.User-
Definned
5.JN-23 steam sterilizer program introduction
Click“program”(Fig.5-1) into the sterilization
program interface(Fig. 5-2) .
5.1 Sterilization program list
Fig.5-1 Fig.5-2
Fig.5-3
For example:Press“Hollow program”icon,into the
interface(Fig.5-3).it is the interface befor the sterilization
program is running.
Running time.“00:00:00”is the time
each Stage.“ALL:00:00:00”is
the whole running.
Temperature.“T1&T2”is temperature inside
chamber.“T3”is temperature of heating
coil.“T4”is temperature of steam generator.
Vacuum times of this program.
Back to the previous interface
Sterilization temperature of this program.
Back to the main interface.
Name of sterilization program.
Water conductivity.
Pressure inside the chamber
Sterilization pressure of this program
Sterilization time of this program
Unlock icon
“ ”Start button.
Page 27 of 58