Page 11
RAPID ADJUSTMENT OF THE LIMITS
Supply cables insert / switch on
When using a light curtain with OSE signal output (connection to terminal X2), please note
Menu item 0.3 rst.
1. Check output rotating direction
2. Move to OPEN nal limit position 3. Save OPEN nal limit position
4. Move to CLOSE nal limit position
5. Save CLOSE nal limit position
After rapid adjustment of the nal limit positions, the door operating mode “Hold-to-run” is
active. The nal limit positions can be corrected later with Menu item 1.1 to 1.4. The pre-limit
is set automatically with safety edge connected. A correction is possible using Menu item
1.5.
To Next Page
Loading...
