Gibertini E50S/3 - Safety; 4.1 Representations and symbols; 4.2 Safety recommendations

Semi
-
micro balance Mod. E50S/3
Page 6 of 38
4 Safety
4.1 Representations and symbols
Important safety instructions are highlighted with the appropriate symbol:
DANGER
Warning of a possible danger that can lead to death or to serious injuries.
CAUTION
Warning of a possibly dangerous situation that can lead to less severe injuries or damage.
NOTE
Tips and important rules on the correct operation of the balance.
4.2 Safety recommendations
 When using the balance in surroundings with increased safety requirements the corresponding
regulations must be observed.
 The balance may only be used with the power adaptor supplied with the E50S/3 balance.
 Before plugging in the power adaptor, make sure that the operating voltage stated on the power adaptor
agrees with the mains voltage. If not, please refer to the Customer Service.
 If the power adaptor or its cable is damaged, the balance must immediately be disconnected from the
electricity supply (pull out the power adaptor). The balance may only be operated with a power adaptor
in perfect condition.
 If there is any reason to believe that it is no longer possible to operate the balance without danger, the
balance must immediately be unplugged from the electricity supply (pull out power adaptor) and secured
against inadvertent operation.
 In carrying out maintenance work, it is essential to heed the recommendations in chapter 12.1
“Maintenance and servicing".
 The balance must not be operated in an area subject to explosion risks.
 Take care when weighing liquids that no liquid is spilt into the inside of the balance or into connections
on the rear of the equipment or the power adaptor.
If liquid is spilt on the balance, the latter must immediately be unplugged from the mains electricity
supply (pull out power adaptor).
The balance may only be operated after it has first been re-checked by a Gibertini Service technician.
 The operating instructions must be read by each operator of the balance and must be available at the
workplace at all times. The balance may only be used for the weighing of solid-materials and of liquids
filled into secure containers and for animal weighing and density determinations. The maximum
allowable load of the balance must never be exceeded, otherwise the balance may be damaged.
 When using the balance in combination with other appliances made by Gibertini as well as with
appliances produced by other manufacturers, the current regulations for the safe use of the relevant
attachments and their application in accordance with instructions must always be observed.