Gibertini E50S/3 - Introduction; 3.1 Useful tips on the Operating Instructions; 3.2 Warranty card; 3.3 Conformity

Semi-micro balance Mod. E50S/3
Page 5 of 38
3 Introduction
E50S/3 balances are simple and functional to operate.
The versatile weighing programs allow you to use the E50S/3 balances not only for simple weighing
procedures but also in a simple manner for carrying out various weighing applications such as, for example,
percentage or component counting weighings and document the measurements obtained accurately and
unequivocally.
The most important basic production features of the E50S/3 balances include:
 Simple-to-use 10-key multifunction control panel
 LCD display with multi-line display
 Anti-theft encoding with four-figure numerical code
 10 user profiles (MUM Multiuser Memory)
 ICM-Autocalibration (intelligent calibration mode)
 RS232/V24 serial interface for data transfer
 ISO- and GLP-compliant reporting of results of measurements
 Capacity and residual tare display
 Storable user-configuration (UMM User Menu Memorized)
 Various application programs:
Piece counting, Percentage weighing, Formulation, Animal weighing, Calculator, Check and reference
weighing
 Statistics program
 Appliance for below-balance weighing
3.1 Useful tips on the Operating Instructions
You should read through these operating instructions in their entirety, so that you can make optimum use of
the full potential and the diverse features of the balance in your daily work.
 Key names are presented in quotation marks and are highlighted in semi-bold script:
 «on/off » or «».
 When explaining the operating steps, the appropriate display for the current operating step is shown for
clarity at the left alongside the list of operating steps:
Display
Key
Step
- - - - - - - -
LANGUAGE ENGLISH
«»
Press repeatedly, until the language currently activated
is displayed.
3.2 Warranty card
A warranty card is enclosed with the instruction manual.
NOTE
Check that the warranty card is enclosed with these operating instructions and is completely filled out.
3.3 Conformity
The balance has been manufactured and tested in accordance with the standards and recommendations set
out in the enclosed certificate of conformity.
The power adaptor produced for the operation of the balance and intended exclusively for this application,
complies with Electrical Protection Class II.