Gibertini E50S/3 - 6.4.2 The print key; 6.4.3 The change key; Application menu; Application Menu Activation and Selection

Semi
-
micro balance Mod. E50S/3
Page 18 of 38
6.4.2 The print key
 Print out an individual value or a report
- Ensure that the balance is in the Weighing mode
- Briefly press «PRINT»
- The individual value or report will be printed out.
 Reset product counter to 1
- Ensure that the balance is in the Weighing mode
- Hold down «PRINT» until “RESET PROD.-COUNTER” is displayed
- Release «PRINT»
- The product counter will be reset to 1.
 Print out a balance status
- Ensure that the balance is in the Weighing mode
- Hold down «PRINT» until “PRINT STATUS” is displayed
- Release «PRINT»
- The balance status will be printed out.
 Print out the application-setup
- Ensure that the balance is in the Weighing mode
- Hold down «PRINT» until “PRINT APPLICATIONS” is displayed
- Release «PRINT»
- The application-setup will be printed out.
 Print out the calibration information
- Ensure that the balance is in the Weighing mode
- Hold down «PRINT» until “PRINT CALIBRATIONS” is displayed
- Release «PRINT»
- Information on the last 50 calibrations is printed. The time and date, as well as the temperature in the
balance at the time of calibration in degrees Celsius. If more than 50 calibrations have been performed,
the oldest are deleted.
6.4.3 The change key
 Switch to other applications
- As long as you hold «», all active applications are shown one after the other: if, for example, the
statistics program, the check program and the count application are activated, “WEIGHING”,
STATISTIC”, “CHECK” and “COUNT” appear in the info-line one after the other:
- Release «» when the application to which the balance should be switched, appears in the display.
6.5 Application menu
The balance application programs are called up using the application menu and adapted to the user’s needs:
Menu Definable functions
SET APP.
Select application program
SETUP APPLICATION
Specify parameters for the application program selected
SET STATISTIC
Statistics and storage functions
SET CHECK +/
-
Define nominal weight and limits for comparison weighing
etc. Other functions available.
Refer to the Application Operating Instructions for the description.
AUTO-START ON/OFF The selected application program can, if required, be loaded automatically every
time the balance is swtiched on
SET USER
Define user profile
 The settings for the sub-menus programmed in works are printed here in bold
 For greater clarity, only that part of the menu tree which corresponds to this application is shown with
 each application description.
 You will find the complete menu tree for the application menu in see chapter 13.2 "Application menu
tree".
 Explanations of the menu functions are printed in italics.