Gibertini E50S/3 - 10.3 Changing the password and password protection; 10.4 Clearing a user; 10.5 Setting the user

Semi-micro balance Mod. E50S/3
Page 29 of 38
The user is defined. Press «esc» to exit the menu.
If there is a password set, it must be entered before making changes in the configuration and application
menus.
NOTE
Make a note of your personal password.
If a user loses his password, he can be enabled again using the password 7 9 1 4.
This password is the same for all balances and is always valid in parallel to the password which the
user has selected.
10.3 Changing the password and password protection
 The password can be entered by entering a new password.
 Password protection can be disabled by resetting the current password to 0 0 0 0.
10.4 Clearing a user
 A user can be cleared by selecting the “CLEAR USER” option in the menu and pressing «» to confirm
this entry.
 If no further users are defined, Work with Users must be activated again in order to facilitate work with
users.
Display
Key
Step
- - - - - - - -
CLEAR USER
«»
Select the “CLEAR USER” menu option.
- - - - - - - -
SET USER
«»
The active user is cleared.
Display
Key
Step
- - - - - - - -
USER EXAMPLE
«»«»
Select the desired user profile and press the «» key to
confirm.
10.5 Setting the user
When the balance is started up, the system asks for the desired user profile.
Display
Key
Step
- - - - - - - -
USER EXAMPLE
«»«»
Select the desired user profile and press the «» key to
confirm.
 If one of the defined user profiles is selected, the corresponding user password must be entered, where
necessary. The user can then work with the balance.
 If “USER GUEST” is selected, any available settings can be defined, although they are not saved.
 If “USER NEW” is selected, the user name and the password must be entered in the application menu in
order to define the user profile.