Gigaset IP BASE - System Settings; Date and Time Configuration

Template Module, Version 2.2, 15.11.2022 / Version - 07.07.2020
Date and time
Gigaset IP BASE / SBG IE-UK-International en / A31008-M3037-S301-1-X119 / settings_WebUI.fm / 3/12/24
38
Settings
Date and time
The date and time must be set so that the correct date and time can be assigned to incoming
calls and the alarm clock can be used. Date and time are synchronised between the handset and
base.
 Settings System Date & Time
The address of a time server on the internet is stored on your phone. The date and time
are taken from this time server provided that the phone is connected to the Internet
and synchronisation with the time server is activated. Manual settings are overwritten
in this case.
24h Time Format:
 Set the desired time format with the switch
= 24-hour time format, e.g. 10:00, 18:00
= 12-hour time format, e.g. 10:00 AM, 06:00 PM
Time Zone:
 Select the time zone in which the phone is operated
Use time from network: The address of a time server on the internet or on the local network is
stored on your phone. By default, the date and time are taken from this
time server provided that the phone is connected to the network and
synchronisation with the time server is activated ( = activated).
The time of the last synchronisation, current date and time are
displayed in the web interface.
Setting the time manually:
 Deactivate the function with the switch ( = deactivated)
 Setting the date and time manually
Time server: Shows the URL or IP address of the time server if Use time from
network is activated.
Default setting: pool.ntp.org or the address of the router if this is set
as the time server.
If another time server is being used on your network, enter this here.
Last synchronisation
with time server: Date and time of the last synchronisation.
Date:Current date
Time:Current time
Save the settings:
 Save