Gigaset IP BASE - Audio Settings; Voice Quality Configuration

Template Module, Version 2.2, 15.11.2022 / Version - 07.07.2020
Audio
Gigaset IP BASE / SBG IE-UK-International en / A31008-M3037-S301-1-X119 / settings_advanced.fm / 3/12/24
46
Audio
Voice quality
The voice quality of VoIP calls is mainly dependent on the codec used for the transmission and
the available bandwidth of the network connection. A "better" codec (better voice quality)
requires more data to be transferred, i.e. it requires a network connection with a larger band-
width.
You can change the sound quality by selecting the voice codecs your phone should use, and
specifying the order in which the codecs are suggested when a VoIP connection is established.
The codec actually used is negotiated between the transmitter and the receiver when estab-
lishing a connection.
Two quality levels with default settings are offered: one optimised for low bandwidths and one
optimised for high bandwidths. You can change the assigned codecs or compile your own codec
preference.
On the web interface
 Settings Telephony Audio Voice quality . . . the connections set up are
displayed with quality level and codecs used next to the entry, click
 Select quality levels with the buttons (High bandwidth / Low bandwidth / Own codec pref-
erence) . . . the button for the selected quality level is shown in orange, the codecs used are
shown according to the selection in the lists Selected codecs and Available codecs
Selected codecs contains the codecs assigned to the quality level
Available codecs contains the codecs available on the phone but not assigned to the
quality level
Remove codec:
 next to the entry, click . . . the codec is moved from the Selected
codecs list to the Available codecs list
Add codec:
 next to the entry, click . . . the codec is moved from the
Available codecs list to the Selected codecs list
Change sequence of
the codecs:
 move an entry in the list Selected codecs up or down
Save the settings:
 Save