77
Setting the base
Gigaset SL400-SL400A / EN for IM-Nord / A31008-M2103-R201-3-SM19 / registr_sett.fm / 01.02.2011
Version 4, 16.09.2005
Restoring the handset
default settings
You can reset individual settings and
changes that you have made.
The following settings are not affected by a
reset:
u Registration of the handset to the base
u Date and time
u Entries in the calendar
u Entries in the directory, SMS lists and the
contents of the resource directory
v
¢
Ï
¢ System ¢ Handset Reset
§Yes§ Press the display key.
Setting the base
The base settings are changed using a regis-
tered Gigaset handset.
Activating/deactivating
music on hold
v ¢
Ï
¢ Audio Settings
¢ Music on hold
Press §Change§ to activate or deactivate the
music on hold (³ = on).
Activating repeater
support
With a repeater, you can increase the range
and signal strength of your base. You will
need to activate repeater mode. This will ter-
minate any calls that are in progress at the
time.
Prerequisite: A repeater is registered.
v
¢
Ï
¢ System ¢ Repeater Mode
Press §Change§ to activate/deactivate repeater
mode (³ = activated).
Switch your handset off and on again
(
¢ page 23), once the repeater has
been activated/deactivated.
Protecting against
unauthorised access
Protect the system settings of the base with
a PIN known only to you. The system PIN
must be entered when, for example, regis-
tering/de-registering a handset to/from the
base or when restoring the default settings.
Changing the system PIN
You can change the 4-digit system PIN set on
the base (default setting: 0000) to a 4-digit
PIN known only to you.
Gigaset SL400A: Setting a system PIN facili-
tates remote operation of the answering
machine (
¢ page 57).
v ¢
Ï
¢ System ¢ System PIN
~ Enter the current system PIN
and press
§OK§.
~ Enter your new system PIN and
press
§OK§.
Please note
u Eco Mode / Eco Mode+ (¢page 60)
and repeater support cancel each
other out, i.e., if you use a repeater,
you cannot use Eco Mode or Eco
Mode+.
u The default encrypted transmission
setting is deactivated when a
repeater is activated.
To Next Page
Loading...
