MDE-5222F
2
Configured Kits - Parts List
FlexPay IV CRIND Retrofit Kits are configured based on the serial number of the pump/dispenser (unit) for
which they are intended. Therefore, the parts list will vary for each configured kit and unit/option type. For
additional parts details, refer to the Bill of Materials (BOM) in the kit, your distributor, or contact Gilbarco
Customer Service. For more information, you can also refer to PT-1937 Encore 300, Encore 500/500 S,
Encore 550, Encore 700 S, Eclipse® Recommended Spare Parts Manual.
A common FlexPay IV CRIND Retrofit Kit will include the following parts:
• CIM™ door with Universal Payment Module (UPM) assembly (keypad), UX300/301 card reader, display,
Peripheral Interface PCB 3 (PIP3)
• T-rail assembly with AFP
• Universal Serial Bus (USB) Printer assembly (for non-CRIND units only)
Configured Kit Optional Components
The following parts are potential configured kit optional components:
• UX400 Contactless
• Applause™ Media System, DCM2, and Gilbarco System on Module (GSoM)
• Cabinet Heater (optional for both 5.7- and 10.4-inch display)
• 2D Imager
• TRIND®
• Intercom
• Keypad Heater Kit (power supply and cable harness)
For a complete parts list of the configured kit, refer to the build ticket that is provided with the kit.
Note: Printers will be needed for non-CRIND units.
To Next Page
Loading...
Need help?
General
