Gill Instruments Ltd
_____________________________________________________________________________________________________________
________________________________________________________________________________________________
WindObserver II Page 9 Issue 18
Doc. No. 1390-PS-0004 January 2009
Mounting Bracket
A mounting bracket is required (not provided) which will attach to the WindObserver II
via the four tapped holes in the base of the unit. Always ensure that the gasket supplied is
fitted to the base of the anemometer.
It is important that the gasket supplied forms a watertight seal on the base of the
anemometer.
In the event that the mounting bracket supplied by the customer is not flat or does not
form complete support for the anemometer base; the customer must fit a mounting ring as
shown in Figure 2.
See Section 6.7 for mounting details.
To Next Page
Loading...
