Gilson Minipuls 3 - Operating Conditions; Solvents; Replacement Parts

Operating Conditions
Access to the rear panel is necessary because the instrument must be
detached from all voltage sources before service, repair, or exchange
of parts. Allow a minimum of 2.54 cm (1in.) space behind the
instrument for proper fan operation.
Operate the instrument using the approved power supply provided
and only at the voltage specified on the rear panel label of the
instrument.
Solvents
Observe safe laboratory practices when handling solvents. If
dangerous liquids are used, adequate protection such as proper
ventilation, safety glasses, etc., should be used. Refer to the Material
Safety Data Sheets for the solvents before use.
Replacement Parts
Be sure to use only replacement parts specified in this user’s guide.
Do not repair or change parts which are not listed in this user’s guide.
If it is necessary to change parts not listed, please contact your local
Gilson representative.
4
SOLVENTS | MINIPULS® 3 PERISTALTIC PUMP
SOLVENTS