Autostart Function
The Autostart Function enables the pump to restart pumping at
power on, in a predetermined way. When the power is restored, the
pump idles regardless of its status when the power was cut. The
display flashes until any key is pressed.
The Autostart Function has three modes, as described in the next
three paragraphs; mode selection is described in the following
paragraph.
Non-autostart Mode
During mode selection, this mode is indicated by a dash “-” to
the left of the identification number. In this mode, each time the
speed is changed, the current speed is stored in non-volatile
memory (provided no other key is pressed within three seconds of
selecting the speed). Subsequently, when the pump is switched on,
the previously selected speed is shown on the display. The pump
operates at this speed when either the or the key is pressed.
Autostart Mode
During mode selection, this mode is indicated by a letter “A” to the
left of the identification number. In this mode, the last speed and
direction are stored in non-volatile memory (provided no other key
is pressed within three seconds of selecting the speed or direction).
Subsequently, when the pump is switched on, the pump operates in
the way that it did before it was switched off.
Hold Mode
During mode selection, this mode is indicated by a letter “H” to the
left of the identification number. In this mode, although speed and
direction changes are effective at the time that they are made, the
non-volatile memory is not updated. When the pump is switched on
again, the pump operates in a way that is pre-determined by the user,
regardless of any changes that were made before it was switched off.
46
AUTOSTART FUNCTION | MINIPULS® 3 PERISTALTIC PUMP
AUTOSTART FUNCTION
To Next Page
Loading...
