Gilson Minipuls 3 - Changing the Unit ID; Routine Maintenance

Changing the Unit ID
The unit ID identifies each instrument to Gilson software packages
that can issue GSIOC commands to the instrument. There is no need
to change this number unless it is the same as that assigned to
another Gilson instrument that’s also connected along the GSIOC.
At the factory, Gilson set the unit ID for the MINIPULS 3 to 30.
To change the unit ID, turn the power OFF. Turn the power ON again
while pressing the STOP key. The display shows “A30”. Using the “+”
and “-” keys, select the desired ID number. Then, press the STOP key
to quit.
Routine Maintenance
The only routine maintenance required is to clean up any spilled
liquids and periodically to clean the outside of the MINIPULS 3 with a
damp cloth.
Replace tubing when it shows signs of wear, such as flatness or
cracking. Damaged tubing can cause excessive pulsations and erratic
flow.
48
CHANGING THE UNIT ID | MINIPULS® 3 PERISTALTIC PUMP
CHANGING THE UNIT ID