Initialization
The safety cover must be installed on the
pump head before operating the pump.
Failure to do so presents a mechanical
hazard to the user.
1 Install tubing as described in Tubing - Selection and Fitting on
page 26.
2 Make sure that the MINIPULS 3 is connected to the external
power supply and that the external power supply is connected to
a power source, using the appropriate power cord for your line
voltage.
3 Switch the pump ON using the rear panel switch. The speed is set
at 12.5 rpm at delivery. The last speed set before switching off is
shown in rpm on the keypad display.
4 Select the desired speed by pressing:
the (-) key to decrease the displayed value,
the (+) key to increase the displayed value.
Pressing either key once changes the right-hand digit by one;
pressing the key continuously makes the speed vary at an
increasing rate.
44
INITIALIZATION | MINIPULS® 3 PERISTALTIC PUMP
INITIALIZATION
To Next Page
Loading...
