COMPUTER CONTROL
To control the MINIPULS 3 from a computer, connect an appropriate
Gilson interface module, or a Gilson RS-232 adapter to the computer.
Next, connect a Gilson Serial Input/Output Channel (GSIOC) cable
between the interface module (or adapter) and the MINIPULS 3, and
any other Gilson devices that are controlled from the same computer.
The 9-position female plug on the GSIOC cable connects directly into
the male socket on the MINIPULS 3 rear panel.
The type of interface module used, and details of how the various
units in the system are interconnected, depend on the complexity of
the system.
Refer to the appropriate user’s guide, and to Chapter 4 | Remote
Control for more details relating to GSIOC connections and
commands.
22
ELECTRICAL | MINIPULS® 3 PERISTALTIC PUMP
ELECTRICAL
To Next Page
Loading...
