6.
At
the garage door opener receiver (motor-head
unit) in the garage, locate the “Learn” or “Smart”
button. This can usually be found where the hanging
antenna wire is attached
to the motor-head unit.
7.
Firmly press and release the “Learn” or “Smart”
button. The name and color of the button may
vary by manufacturer.
You will have
30
seconds
to
start Step
8.
8.
Return
to
the vehicle. Firmly press and hold the
programmed HomeLink@ button for two seconds,
then release. Repeat the press/hold/release
sequence a second time, and depending on the
brand of the garage door opener (or other rolling
code device), repeat this sequence a third time
to
complete the programming.
HomeLink@ should now activate your rolling code
equipped device.
To program the remaining two HomeLink@ buttons,
begin with Step
2 of “Programming HomeLink@.”
Do not repeat Step
1.
Gate Operator and Canadian
Programming
Canadian radio-frequency laws require transmitter
signals
to
“time out” or quit after several seconds of
transmission. This may not be long enough for
HomeLink@ to pick up the signal during programming.
Similarly, some
U.S.
gate operators are manufactured to
“time out” in the same manner.
If
you live in Canada, or you are having difficulty
programming a gate operator by using the
“Programming HomeLink@
”
procedures (regardless
of
where you live), replace Step
3
under “Programming
HomeLink@
I’
with the following:
Continue
to
press and hold the HomeLink@ button while
you press and release every two seconds (cycle) your
hand-held transmitter until the frequency signal has been
successfully accepted by HomeLink@
=
The indicator
light will flash slowly at first and then rapidly. Proceed
with Step
4
under “Programming HomeLink@”
to
complete.
2-44
To Next Page
Loading...
