Playing a Disc
To play a disc, gently insert the disc with the label side
up into the loading
slot. The DVD player will continue
loading the disc and the player will automatically start.
If a disc is already in the player, press the play/pause
button on the face of the player or on the remote control.
Some DVDs will not allow you
to
fast forward or skip
the copyright or previews. Some DVDs will begin playing
after the previews have finished. If the DVD does not
begin playing, refer
to
the on-screen instructions.
Stopping and Resume Playback
To
stop a disc, press and release the stopleject button
on the DVD player or the
stop
button on the remote.
To
resume playback, press the play/pause button on the
DVD player or the remote.
As long as the disc has
not been ejected and the stop button has not been
pressed twice on the remote control, the movie should
resume play from where
it
was last stopped. If the
disc has been ejected or
if
the stop button on the remote
has been pressed twice, the disc will resume play at
the beginning.
Parental Control
Button: This button is located on the
front of the DVD console which is mounted vertically
above the driver’s right shoulder. Press this button while
a DVD is playing
to
freeze the video and mute the
audio
to
the headphones.
It
will also disable all other
button operations from the remote and DVD player.
The driver will then be able
to
gain the attention of the
rear seat passengers. Press this button again
to
restore normal play of the DVD.
Ejecting
a
Disc
Press the stop/eject button on the DVD player once
to
stop and a second time
to
eject the disc.
If
a disc is ejected from the player, but
not
removed, the
DVD player will reload the disc after approximately
10
to
20
seconds.
3-96
To Next Page
Loading...
