Playing
a
Cassette Tape
Your tape player is built
to
work best with tapes that are
up
to
30
to
45
minutes long on each side. Tapes
longer than that are
so thin they may not work well in
this player. The longer side with the tape visible should
face
to
the right.
If
the ignition is on, but the radio is
off,
the tape can be inserted and will begin playing.
A tape symbol is shown on the display whenever a tape
is inserted. If you hear nothing but a garbled sound,
the tape may not be in squarely. Press EJT
to
remove
the tape and start over.
While the tape is playing, use the
VOL,
AUDIO and
SEEK controls just as you do for the radio. The display
will show TAPE and an arrow showing which side of
the tape is playing.
If you want
to
insert a tape while the ignition is off,
first press EJT or DISP.
If an error appears on the display, see “Cassette Tape
Messages” later in this section.
1
PREV (Previous): Your tape must have at least three
seconds of silence between each selection for previous
to work. Press this pushbutton
to
go
to
the previous
selection on the tape
if
the current selection has been
playing for less than three seconds. If pressed when the
current selection has been playing from
3
to
13 seconds,
it will go
to
the beginning of the previous selection or
the beginning of the current selection, depending upon
the position on the tape.
If
pressed when the current
selection has been playing for more than 13 seconds,
it will
go
to
the beginning of the current selection.
SEEK and a negative number will appear on the display
while the cassette player is in the previous mode.
Pressing this pushbutton multiple times will increase the
number of selections
to
be searched back, up
to
-9.
2
NEXT:
Your tape must have at least three seconds of
silence between each selection for next to work. Press
this pushbutton
to
go
to
the next selection on the tape.
If
you press the pushbutton more than once, the player
will continue moving forward through the tape. SEEK and
a positive number will appear on the display.
3
REV (Reverse): Press this pushbutton
to
reverse the
tape rapidly. Press it again
to
return
to
playing speed.
The radio will play while the tape reverses. The
station frequency and
REV
will appear on the display,
You may select stations during reverse operation
by using the TUNE and SEEK.
3-77
To Next Page
Loading...
