Using
Song
List
Mode
The integrated six-disc CD changer has a feature called
song list. This feature
is
capable of saving
20
track
selections.
To save tracks into the song list feature, perform the
following steps:
1.
Turn the disc player on and load it with at least one
disc. See “LOAD CD” listed previously in this
section for more information.
2.
Check
to
see that the disc changer is not in song
list mode. S-LIST should not appear in the display.
If
S-LIST is present, press the SONG LIST
button to turn
it
off.
3.
Select the desired disc by pressing the numbered
pushbutton and then use the SEEK SCAN right
arrow button to locate the track that you want
to
save. The track will begin to play.
4.
Press and hold the SONG LIST button for two or
more seconds
to
save the track into memory.
When SONG LIST is pressed a beep will be heard
immediately. After two seconds
of
pressing
SONG LIST continuously, two beeps will sound
to
confirm that the track has been saved.
5.
Repeat Steps
3
and
4
for saving other selections.
If you attempt
to
save more than 20 selections, S-LIST
FULL will appear on the display.
To play the song list, press the SONG LIST button.
One beep will be heard and S-LIST will appear on the
display. The recorded tracks will begin to play in
the order that they were saved.
You may seek through the song list by using the
SEEK
SCAN arrows. Seeking past the last saved track will
return you
to
the first saved track.
To delete tracks from the song list, perform the following
steps:
1.
Turn the disc player on.
2.
Press the SONG LIST button to turn song list on.
S-LIST will appear on the display.
3.
Press the SEEK SCAN arrows to select the desired
track to be deleted.
4.
Press and hold the SONG LIST button for two
seconds. When pressing SONG LIST, one beep
will be heard immediately. After two seconds
of pressing the SONG LIST button continuously,
two beeps will be heard
to
confirm that the track has
been deleted.
3-90
To Next Page
Loading...
