Q*
+d
(Mode): Press this button
to
manually select the air
delivery mode
to
the floor, instrument panel, or
windshield outlets. The system will stay in the selected
mode until the mode button is pressed again or the
AUTO button is pressed.
Driver’s Side Temperature Knob: Turn this knob
clockwise or counterclockwise
to
manually raise or lower
the temperature on the driver’s side of the vehicle. The
display will show the temperature setting decreasing or
increasing and the word “DRIVER” will light up. This knob
can also adjust the passenger’s side temperature setting
simultaneously
if
the two zones are linked. The words
“DRIVER and PASS’’ will then light up.
Passenger’s Side Temperature Knob: Turn this knob
clockwise or counterclockwise to manually raise or lower
the temperature on the passenger’s side of the vehicle.
The display will show the temperature setting decreasing
or increasing and the word “PASS’’ will light up. The
passenger’s temperature setting can be set
to
match and
link
to
the driver’s temperature setting by pressing and
holding the AUTO button for three seconds. By adjusting
the driver’s side temperature setting, the passenger’s
side temperature setting will follow and both “DRIVER
and PASS” will be displayed. The passenger’s side
temperature setting also resets and relinks
to
the driver’s
side temperature setting
if
the vehicle has been
off
for
more than two hours.
Automatic
Operation
AUTO (Automatic): When automatic operation is
active, the system will control the inside temperature,
the air delivery mode, and the fan speed.
Use the steps below
to
place the entire system in
automatic mode:
1.
Press the AUTO button.
When AUTO is selected, the air conditioning
operation and air inlet will be automatically
controlled. The air conditioning compressor will run
when the outside temperature is over approximately
40°F
(4°C). The air inlet will normally be set
to
outside air. If it’s hot outside, the air inlet will
automatically switch
to
recirculate inside air
to
help
quickly cool down your vehicle.
2. Set the driver’s and passenger’s temperature.
To
find your comfort setting, start with a 72°F (22°C)
temperature setting and allow about
20
minutes
for the system
to regulate. Turn the driver’s or
passenger’s side temperature knob
to
adjust the
temperature setting as necessary. If you choose the
temperature setting of 60°F (15°C)’ the system
will remain at the maximum cooling setting. If you
choose the temperature setting
of
90°F
(32°C)’
the system will remain at the maximum heat setting.
Choosing either maximum setting may not cause
the vehicle
to heat or cool any faster.
3-24
To Next Page
Loading...
