Shifting Out of
4LO
To shift from 4LO
to
4HI, A4WD or 2HI your vehicle
must be stopped or moving less than 2 mph (3.2 km/h)
with the transmission in NEUTRAL (N) and the
engine running. The preferred method for shifting out
of 4LO is
to
have your vehicle moving
1
or 2 mph
(1.6
to
3.2 km/h). Turn the knob
to
4HI, A4WD or 2HI.
You must wait for the 4HI, A4WD or 2HI indicator light
to
stop flashing and remain illuminated before shifting
your transmission into gear.
If the 4HI, A4WD or 2HI knob is turned when your
vehicle is in gear and/or moving, the 4HI, A4WD or
2HI indicator light will flash for 30 seconds but will
not complete the shift unless your vehicle is moving
less than 2 mph (3.2 km/h) with the transmission
in NEUTRAL (N).
Shifting into NEUTRAL
Before shifting the transfer case
to
NEUTRAL, first
make sure the vehicle is parked
so that it will not roll.
1.
Set the parking brake.
2. Start the vehicle.
3.
Connect the vehicle
to
the towing vehicle.
4. Put the transmission in NEUTRAL (N).
5.
Shift the transfer case
to
2HI.
6. Turn the transfer case knob all of the way past 4LO
and hold it there for a minimum of
10
seconds. The
neutral indicator light will come on.
second, then shift the transmission
to
DRIVE
(D)
for one second.
7.
Shift the transmission
to
REVERSE
(R)
for one
8.
Place the transmission shift lever in PARK (P).
9.
Turn the ignition
to
LOCK.
10.
Release the parking brake prior
to
towing.
Shifting Out of NEUTRAL
To shift the transfer case out of NEUTRAL,
do
the
following:
1.
Set the parking brake and apply the regular brake
pedal.
2.
Start the vehicle with the transmission in PARK (P).
3. Turn the transfer case knob
to
the desired shift
position (2HI, 4HI or A4WD).
4. Put the transmission in NEUTRAL (N).
5.
After the transfer case has shifted out of NEUTRAL,
the indicator light will
go
out. Shift the transmission
lever
to
the desired position.
A re-engagement sound is normal when shifting out of
NEUTRAL.
2-28
To Next Page
Loading...
