Programmable Unlocking Feature
The following
is
the list of available programming
options:
Mode
1:
Driver’s door unlocks when the transmission is
shifted into PARK (P).
Mode
2:
All doors unlock when the transmission is
shifted into PARK (P).
Mode
3:
All doors unlock when the key is removed
from the ignition.
Mode
4:
No
automatic door unlock.
The automatic door locks were pre-programmed at the
factory to unlock the driver’s door once the transmission
is shifted to PARK (P). The following instructions detail
how to program your door locks differently than the
factory setting. Choose one of the four programming
options listed above before entering the program mode.
To
enter the program mode you need to do the
following:
1.
Begin with the ignition off. Then pull the turn
signal/multifunction lever toward you and hold
it there while you perform the next step.
2.
Turn the key to
RUN
and LOCK twice. Then, with the
key in LOCK, release the turn signal/multifunction
lever. Once you do this, you will hear the lock switch
lock and unlock, the horn will chirp twice, and a
30
second program timer will begin.
3.
You are now ready to program the automatic door
locks. Select one of the four programming options
listed above, and press the unlock side of
the power door lock switch to cycle through the
unlocking options. You will have
30
seconds
to begin programming.
If
you exceed the
30
second limit, the locks will automatically lock
and unlock and the horn will chirp twice to
indicate that you have left the program mode.
If this occurs, repeat the procedure beginning with
Step
1
to re-enter the programming mode.
You can exit the program mode any time by turning the
ignition to
RUN.
The locks will automatically lock and
unlock and the horn will chirp twice to indicate that you
are leaving the program mode. If the lock/unlock
switches are not pressed while in the programming
mode, the current auto lock/unlock setting will not be
modified.
See your dealer for more information.
2-1
1
To Next Page
Loading...
