EasyManua.ls Logo

GMC 2003 Envoy XL - Battery Not Charging; DIC Warnings and Messages; Engine Coolant Hot;Idle Engine; Oil Pressure Low;Stop Engine

GMC 2003 Envoy XL
458 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DIC
Warnings and Messages
Warning messages are displayed on the DIC
to
notify
the driver that the status
of the vehicle has changed and
that some action may be needed by the driver
to
correct the condition. More than one message may
appear at one time. They will appear one behind
the other. Some messages may not require immediate
action but you should press the select button
to
acknowledge that you received the message and clear
it from the display. Some messages cannot be
cleared from the display because they are more urgent.
These messages require action before they can be
removed from the DIC display. The following are
the possible messages that can be displayed and some
information about them.
ENGINE COOLANT HOT/IDLE ENGINE
If
the cooling system temperature gets hot, this
message will appear in the DIC and you will hear a
chime. Stop the vehicle and let the engine idle in
PARK
(P)
to
allow the coolant
to
reach a safe
temperature. This message will clear when the coolant
temperature drops
to
a safe operating temperature.
OIL PRESSURE LOW/STOP ENGINE
If low oil pressure levels occur, this message will
be displayed on the DIC. Stop the vehicle as soon as
safely possible and
do
not operate it until the cause
of the low oil pressure has been corrected. Check your
oil as soon as possible and have your vehicle
serviced.
BATTERY NOT CHARGING
If the battery is not charging during operation, this
message will appear on the DIC. Driving with this
problem could drain your battery. Have the electrical
system checked as soon as possible. Pressing the
select button will acknowledge this message and clear
it from the DIC display.
SERVICE
AIR
BAG
If there is a problem with the air bag system this
message will be displayed on the DIC. Have a qualified
technician inspect the system for problems. Pressing
the select button will acknowledge this message
and clear it from the DIC display.
3-60

Table of Contents

Related product manuals