GMI Shipsurveyor - Warm-Up Complete; Alarms (CSM Mode Only)

3-22
USER HANDBOOK
3.12 Warm-up Complete
The instrument will now display the current gas readings
for the selected mode. Fig. 3-33 illustrates the display for a
Shipsurveyor 1 in CGI mode.
Fig. 3-33 LEL Display
3.13 Alarms (CSM mode only)
If alarms are enabled, an ‘A’ character is displayed in the top
RH corner of the screen as illustrated in Fig. 3-34.
Fig. 3-34 Alarm Enabled Identier
Alarm levels are set as per the configuration of the
instrument.