GLUTE BLASTER INSTRUCTIONS
ATTACHING & ADJUSTING GLUTE BLASTER:
1. Pull belt through buckle so the Glute Blaster logo is facing out.
2. Tighten belt until it is comfortable around your waist or hips,
then fasten Velcro. Be sure that the buckle is
resting on either side of your hip, and not directly on it.
3. Positioning—Slide the tubes so the GoFit belt attachments
are in line with the middle of each glute.
4. Kneeling down, firmly pull the foot strap at the base of tube
towards the corresponding foot. Place the foot strap
(padded side up) under the arch of your foot, step securely
on foot strap and fasten Velcro on the top of your foot with
GoFit logo facing up. Carefully switch legs and attach the
other foot strap
3.
4.
2.
1.
To Next Page
Loading...
