124
2. Enter the RSTe configuration interface shown in Figure 6-16 (see Table 1-29 for interface
descriptions). Please refer to the key operation tips on the lower border of the interface to navigate and modify
settings in the interface. Figure 6-16 RSTe configuration interface
Figure 6- 16
Table 1-37 Description of the RSTe configuration interface
On the upper side of the interface, you can perform the following tasks:
1.Create RAID Volume: Configure RAID volume.
2.Delete RAID Volume: Delete RAID volume.
3.Reset Disks to Non-RAID: Clear the RAID configuration information
of the disk.
4.Mark Disks as Spare: Configure a hot spare disk.
5.Exit: Exit.
On the lower side of the configuration interface, you can view the
overview information of the created RAID and physical disks.
Table 1- 37
Common tasks
Configure RAID:
1. Enter the RSTe configuration interface.
2. As shown in Figure 6-17, select Create RAID Volume on the RSTe configuration interface, and press
Enter.
Figure 6-17 RSTe configuration interface
To Next Page
Loading...
Need help?
General
