123
Figure 6- 14
Enter the RSTe configuration interface
1. Power on or restart the server, and press Ctrl+I when the interface shown in Figure 6-15 is displayed
during the BIOS startup process.
Figure 6-15 BIOS startup interface
Figure 6- 15
If the working modes of both sSATA and SATA controllers are set to RAID, the prompt "Press
<CTRL-I> to enter Configuration Utility" will appear twice during BIOS startup, corresponding to sSATA and
SATA controllers in turn. Please configure RAID according to the The desired disk selection controller.
To Next Page
Loading...
Need help?
General
