SECUTEST ST BASE(10) / PRO and SECULIFE ST BASE(25)
20 Gossen Metrawatt GmbH
The standard designation cannot be
changed retroactively! Stored mea-
surements retain the standard desig-
nation and it’s used in the test report.
For this reason, select the standard
designation carefully during initial
startup.
As soon as the standard designation
has been changed, the new designa-
tion is used in all future tests.
Standards which are not needed can be
deactivated in order to increase clarity.
The settings can be found under SETUP > Auto
Measurements. Each standard for which a test
sequence is integrated is displayed there.
➭ SETUP 1/3 > Auto Measurements.
➭ Scroll through the menu pages until the
individual standards appear.
➭ Select the first standard via the softkey.
All possible standard designations are
displayed.
(An overview of all available standard
designations can be found on the follow-
ing page).
➭ Select the desired standard designation
with the corresponding softkey.
Alternatively, the standard (the test se-
quence) can be deactivated by selecting
the off entry.
The menu is returned to the standards
display in Auto Measurements.
➭ Repeat this procedure for all standards.
➭ Finally, confirm with the green check-
mark. The settings are saved.
Overview of Integrated Standards
Availability of the individual integrated
test sequences depends on the test
instrument type (SECUTEST ST... or
SECULIFE ST...), the selected fea-
tures (order features) and the
enabled extensions (activations).
Refer to your order / test instrument
and data sheet for details.
SETUP > Auto Measurements
4/7 > VDE 0701-0702 >
Off
OVE E 8701
SNR 462638
VDE 0701-0702
5/7 > IEC 62353 >
Off
EN 62353
IEC 62353
VDE 0751-1
5/7 > IEC 60974-4 >
Off
EN 60974-4
IEC 60974-4
VDE 0544-4
5/7 > NEN 3140 >
Off
NEN 3140
6/7 > EN 50678 >
Off
EN 50678
VDE 0701
6/7 > EN 50699 >
Off
EN 50699
VDE 0702
6/7 > IEC 62368 >
Off
EN 62368
IEC 62368
VDE 0868-1
7/7 > IEC 62911 >
Off
EN 62911
IEC 62911
VDE 0868-911
To Next Page
Loading...
