Grace Continuum II - Building the Frame Table

11
On both table sections: Use the 4 mm T-handle Allen wrench to remove eight M6 x 10 mm
connector bolts attaching the metal track extrusions.
1
Step 2 - Building the Frame Table
Parts & Tools Needed:
14
17
Allen Wrench 5 mm
SBHCS Screw
M8 x 16 mm (x36)
Table Section (x2)
Corner Brace (x4)
Middle Leg
Brace (x2)
Full Frame Assembly
Right Leg
Left Leg
Middle Leg
4 mm
T-Handle Allen
Wrench 4 mm
(Box 1: Inner Box)
(Box 1: Inner Box)
(Box 2)
Instructions
Attach the table tops to the frame legs by taking the following steps:
(Box 1: Inner Box)
M6 x 10 mm
Connector Bolt (x8)
Table Section