Graco 695 XT - Page 43

Repair
3B0070C 43
Replacing the Shroud
1. Ensure tabs on inside top of shroud
align with grooves on the control board
channel. The top shroud tabs must slide
into the control board grooves. Side
edges should align to bottom shroud in
the side grooves.
2. Push gently down on top of the shroud
and using a T20 tool, tighten two Torx
T20 screws to 12-16 in.-lbs.
3. Using a 1/4 in. socket, tighten two front
screws to 20-25 in.-lbs.
4. Align front cover and using a 1/4 in.
socket, tighten front screws to 20-25
in.-lbs.