Grandstream Networks WP810 Administration Guide

P a g e | 43
WP810 Administration Guide
Version 1.0.7.83
Send DTMF
This parameter specifies the mechanism to transmit DTMF digits. There are
3 supported modes:
• In audio: DTMF is combined in the audio signal (not very reliable with low-
bit-rate codecs).
• RFC2833 sends DTMF with RTP packet. Users can check the RTP packet
to see the DTMFs sent as well as the number pressed.
• SIP INFO uses SIP INFO to carry DTMF.
Default setting is “RFC2833”.
Account/Call Settings
Dial Plan
Configures the dial plan rule. For syntax and examples, please refer to user
manual for more details.
Call Log
Configures Call Log setting on the phone. You can log all calls, only log
incoming/outgoing calls (missed calls will not be logged) or disable call log.
The default setting is “Log All Calls”.
Send Anonymous
If set to “Yes”, the “From” header in outgoing INVITE messages will be set to
anonymous, blocking the Caller ID to be displayed. Default is “No”.
Anonymous Call
Rejection
If set to “Yes”, anonymous calls will be rejected.
The default setting is “No”.
Auto Answer
If set to “Yes”, the phone will automatically turn on the speaker phone to
answer incoming calls after a short reminding beep. Default setting is “No”.
Refer-To Use Target
Contact
If set to “Yes”, the “Refer-To” header uses the transferred target’s Contact
header information for attended transfer. The default setting is “No”.
Transfer on
Conference Hangup
Defines whether the call is transferred to the other party if the conference
initiator hangs up.
Disable Recovery on
Blind Transfer
Disable recovery to the call to the transferee on failing blind transfer to the
target.
Blind Transfer Wait
Timeout
Defines the timeout (in seconds) for waiting SIP frag response in blind
transfer. Valid range is 30 to 300.
Blind Transfer Wait
Timeout
Defines the timeout (in seconds) for waiting SIP frag response in blind
transfer. Valid range is 30 to 300.
No Key Entry Timeout
Defines the timeout (in seconds) for no key entry. If no key is pressed after
the timeout, the digits will be sent out.
Key As Send
Pressing selected key will immediately dial out.
RFC2543 Hold
Allows users to toggle between RFC2543 hold and RFC3261 hold. RFC2543
hold (0.0.0.0) allows user to disable the hold music sent to the other side.
RFC3261 (a line) will play the hold music to the other side.
Disable Call Waiting
Enables / disables the call waiting feature for the current account. When set
to “Default”, global call feature setting will be used. Default setting is Default.

Grandstream Networks WP810 Specifications

General

Brand	Grandstream Networks
Model	WP810
Category	IP Phone
Language	English