2-11
Checks and Preparation
2.7 Mounting and Removing Input Terminals
Input terminals can be mounted or removed.
Removing the terminals will allow you to easily connect signal wires.
WARNING
Make sure the signal source is OFF while connecting the wires to avoid electric shock.
CAUTION
• Make sure the device is powered off when mounting or removing input terminals.
• Make sure the signal source is OFF when mounting or removing input terminals.
• Handle the input terminals with enough care when mounting or removing them.
Do not pull or push terminals with excessive force.
Removing Input Terminals
(1) Remove the two screws, as shown in the figure below.
*When you mount the input terminals, tighten the screws to a torque of 6 to 8 kgf/cm.
(2) Pull the input terminals out in the direction indicated by the arrow to remove them.
(3) Connect signal wires to the terminals.
(4) Mount the terminals by following the above procedures in reverse order.
To Next Page
Loading...