GRAPHTEC MT100 - Attaching USB Memory; Inserting a USB Memory; Supported USB Memory Dimensions

2-15
Checks and Preparation
2.9 Attaching USB Memory
Attaching USB memory to the MT100 allows you store measured data directly.
CAUTION
Adequate precautions against static electricity must be taken when handling USB memory.
Inserting a USB Memory
Attach the USB memory to the USB memory terminal.
Supported USB Memory Dimensions
The following figure shows the maximum USB memory dimensions supported by this device.
CAUTION
When you attach the USB memory to MT100, be careful during handling so as not to bump or drop the unit.
<Specifications of supported USB memory>
• Power source : +5 V
• Power consumption : 250 mA or below
• Capacity : No limit (except each file must be within 2 GB)
* USB memory with security functions such as fingerprint authentication cannot be used.
USB memory
47mm
90mm
13mm
8.5mm
Front
21.5mm