3-12
Settings and Measurement
3.3 Operation Modes
You can check the system operation status in the simplified message display.
Operation status transition
(1) Free Running
When in Free Running status, you primarily set up the system to capture data.
You can check the current input signal as a waveform or digital values.
Operations available during Free Running
ReplayingCapturing
Dual View Replaying
Free Running
［REVIEW］ key
［QUIT］ key
［QUIT］key［REVIEW］key
［START/STOP］ key
［START/STOP］ key
operation operation
simplified message display
Free Running Start up status or data is not being captured Free Running
Capturing Data is being captured in the main memory Memory Recording
or USB device. USB Drv Recording
Dual View Replaying
The current waveform display and data on capturing Memory Recording
is being replayed USB Drv Recording
Replaying Captured data is being replayed Memory Review
USB Drive Review
Measuement parameters settings
The MENU key is used to change various setting items in configuration menus.
SPAN/TRACE/POSITION The SPAN/TRACE/POSITION key is used to change settings.
Display mode The DISPLAY key is used to change the display mode.
Data replay The REVIEW key is used to replay captured data.
To Next Page
Loading...