iv
Safety Precautions
Safety Precautions
WARNING
Be sure to securely connect the MT100's power cord.
• After checking that the Power switch is turned off, connect the power cord's
female plug to the MT100 and then connect its male plug into the electrical
socket.
• Use of the MT100 without the power cord securely plugged into the
electrical socket may result in electrical shock due to current leakage.
If the MT100 generates smoke, is too hot, emits a strange odor, or otherwise functions abnormally, turn off
the Power switch and power source, and disconnect the power cable.
• Use of the MT100 in such status may result in a fire hazard or electrical
shock.
• After checking that smoke is no longer being generated, contact your sales
representative or nearest Graphtec vendor to request repair.
• Never try to perform repair yourself. Repair work by inexperienced
personnel is extremely dangerous.
Before turning on the MT100, ensure that the electric socket's supply voltage conforms to the MT100's
power rating.
• Use of a different supply voltage may cause damage to the MT100 or a fire
hazard due to electrical shock or current leakage.
Never disassemble or remodel the MT100.
• Such action may cause a fire hazard due to electric shock or current
leakage.
• Contact with a high-voltage component inside the MT100 may cause
electric shock.
• If repair is required, contact your sales representative or nearest Graphtec
vendor.
Avoid using the MT100 in extremely dusty or humid places.
• Such use may cause a fire hazard due to electrical shock or current
leakage.
Securely connect the power cord
Make sure that the socket has a good
protective ground
Use of a different
supply voltage
prohibited
Amateur repair
prohibited
No disassembly
Use prohibited
Watch out for
electrical shock
To Next Page
Loading...