GRAPHTEC MT100 - Span;Trace;Position; Quit (Local)

To Next Page

To Previous Page

3-7

Settings and Measurement

(2) SPAN/TRACE/POSITION

Pressing this key switches the displayed contents in the digital display.

Used to change the settings related to waveform display during free running (when stopped), data

capture and data replay.

MONITOR

Displays measurement values of each channe

(default).

SPAN

Allows changing of the span value.

• Channel change: keys

• Span change: keys

• Change range: Eight voltage levels and six

temperature levels

POSITION

Allows changing of the waveform position.

• Channel change: keys

• Position change: keys

• Change range: Range can be changed in units of 10%.

TRACE

Allows turning ON/OFF of the waveform display.

• Channel change: keys

• Trace change: keys

• Change range: ON/OFF

* Data capture is enabled even with the OFF setting.

(3) QUIT (LOCAL)

This key is primarily used for the following operations.

• To cancel a setting during menu configuration.

• To return to the MONITOR window when the SPAN/TRACE/POSITION window is displayed.

• To cancel remote status (in which keys are disabled) through interface control.

• To close the menu screen.

• To quit data replay.

• To return the Digital + Calculation Display Screen/Bar Graph Screen to the Waveform + Digital Screen.

SPAN/TRACE/POSITIONke