2-19
Checks and Preparation
2.12 Attaching the Desktop Case (B-541)
This section describes how to attach the desktop case.
WARNING
Make sure the power and input signal terminal cables are removed while attaching the desktop case to
avoid electric shock.
Case Set Contents
Desktop case: 1 Power cable: 1
M3 x 6 mm screws: 4 Assembly instruction manual: 1
To Attach
(1) Insert the MT100 into the desktop case from
the direction shown in the figure below.
(2) Fix the case to the device from the bottom
surface using the four screws provided.
(four M3 x 6 mm binding screws)
*Recommended screw torque: 8 to 10 kgf/cm
Desktop case
MT100
Bottom surface
To Next Page
Loading...