GRAPHTEC MT100 - Page 67

3-28
Settings and Measurement
Win In: Used to specify the upper and lower limits for each channel.
When the signal level goes within (or is within) either limit, a trigger/
alarm is generated.
Win Out: Used to specify the upper and lower limits for each channel.
When the signal level goes outside (or is outside) either limit, a trigger/
alarm is generated.
Rate of Change Alarm
Ex) When Data Points of RC Alarm is set to 3.
(4) DISP settings
This menu allows you to make display-related settings.
CH.1
Measurement starts (alarm generated)
Trigger (alarm) generated area
Set upper level
Set lower level
CH.1
Measurement starts (alarm generated)
Set lower level
Set upper level
Trigger (alarm) generated area
ThetotalamountofchangeinthethreepointsAnalarmisgenerated.
isequaltoorlessthanthespecifiedvalue(ΔV).Alarmisnotgenerated.
Thetotalamountofchangeinthethreepoints

exceedsthespecifiedvalue(ΔV)
Alarmisgenerated
Items Settings 1 Settings 2 Selections available
Format Settings Waveform Scroll Direction Vertical, Horizontal
Number of Display Zones 1, 2, 5, 10 zone
Compression Magnification 1/10, 1/20, 1/30, 1/40, 1/50, 1/60, 1/70, 1/80, 1/90, 1/100
Bar Graph Settings Bar Graph Display Standard, Center
Waveform Display Settings Color red: 0 to 31, green: 0 to 31, blue: 0 to 31
Width 1, 2, 3, 4, 5, 6, 7, 8 dots
Trace On, Off