3-56
Settings and Measurement
(Ex.3) Setting the USB memory device as the destination for data capture
The following procedure shows how to set the USB memory device as the location to capture measurement data.
This setting allows data to be captured into a file automatically created in the USB memory device.
(1) Press the MENU key to open the DATA menu.
(2) Use the key to move the cursor to File Name and press the ENTER key.
(3) Press the ENTER key in Folder.
(4) Use the key to move the cursor to USB1 and press the ENTER key.
Movecursor Confirm
To Next Page
Loading...