Graphtech Ghost - Tools Required; Optional Tools

To Next Page

To Previous Page

Required Tools

• Electric drill and 5/16” bit (12” long recommended) for

drilling hole between cavities and starting 13-pin jack

hole; 9/32” bit for adding optional pots; 5/64” bit for

13-pin jack mounting plate holes; and 1/4” bit for installing

optional QuickSwitches

• Small round needle le for pick guard notches

• Screw driver for changing saddles and setting intonation

• Phillips screw driver for removing pick guard or cavity cover

• Soldering iron (25W) for Acousti-Phonic 1/4” jack and

acoustic volume pot harnesses

• Wire stripper / cutter

• 3/8” chisel for shaping 13-pin jack hole

• Olfa or X-Acto knife

• Masking tape

Optional Tools

• Dremel and 1/8” cutting bit for pick guard notches

• Router and 3/8” bit for shaping 13-pin jack hole