45
Locate the Hexpander where it can accept plug-in connections
from the 13-pin jack, the saddle pickups, and the battery and
options if applicable. When piggybacking with the Acousti-Phonic,
mount the pair of boards on the cavity wall or rear cover plate using
the self-adhesive foam supplied with the Acousti-Phonic. For
Hexpander-only installations, the Hexpander can be left suspended
inside the control cavity, as the rigidity of the ribbon cable and
other wires will stabilize it suciently. If there is any possibility of
the Hexpander coming into contact with cavity shielding or other
electrical components, wrap the Hexpander in electrical tape to
insulate it, or add two layers of adhesive foam to the back of the
Hexpander board and mount it to the cavity wall or rear cover plate.
Hexpander
To Next Page
Loading...
Need help?
General